If you've got a ballast out on your Nissan, Infiniti, Acura, or Honda; buying a new OEM replacement certainly is not cheap!
If you're doing a quad retrofit on a vehicle with factory HID headlights, these will allow you to run a splitter and relay harness off the factory ballast wiring without any splicing.
No Matter What.
These convenient adapters allow the use of aftermarket parts in place of expensive Original-Equipment ballasts with zero cutting, splicing, or re-wiring involved.
Made with stranded copper wire, fully sealed male and female connections, and protected with tech-flex mesh in between; these adapters should last longer than your original ballasts did!
Available to fit the OE-side connector on most modern Nissan, Infiniti's, Acura's, and Hondas that use Panasonic/Matsushita Gen III or IV ballasts, or Mitsubishi Electric Gen II or III Ballasts.
This kit includes
Brake Lights So bright they can't be missed. The Morimoto 5Stop LED brake lights uses five strong 5W Red LED's to illuminate the rear-end of your bike and indicate to...
Hella OEM. Couple this abrasion-resistant TechFlex mesh sleeving with our cloth harness tape for the best wiring job possible. Hella Clean. Convoluted plastic tubing has no place in a quality...
No substitutes If you're still running oldschool halogen headlights on your F150, then you're just behind the times! Thankfully the new Morimoto XB LED headlights: Look great. Are well-built. Have a virtually...